ZJ型减速器
ZJ型减速器是平等轴成折线布置,二级圆柱硬齿面齿轮传动.是采用涨圈无键联接和接触式模块逆止器等结构的套装式减速器。
ZJ型减速器主要用于固定式输送机,特别在斗式提升机中得到广泛应用,也运用于其它多种机械传动中。
工作条件
输入轴转速不大于1500r/min;
工作环境温度为-20"C~ +45'C.当环境温度低于0'C时,必须采用润滑油加热装置,使油温超过0'C时才能启动。
可正反两向运转。
型式
装配型式ZJ型减速器按空心输出轴端分为闷盖(m)和通盖(T).输出端的旋转方向有双向(L),顺时针单向(S),逆时针单向(N): 按输轴装配型式分为右(1)装和左装(11)。减速器共有12种装配型式。
ZJ decelerator
ZJ decelerator is a set decelerator with equql shaft diagonal in stallation,two stage hard tooth gear driving,up ring no-shaft connection and tangent model arrester.
Zj decelerator is applied in ftting transporter especially in lifter.
working condition
The input shaft rotating speed in no more than 1 500r/min
The ambient temperature is ,the lubricating oil must be heated up to 0'C when it is below that.
Both forward and backward operation are applied.
Type
Installing form
The hollow shaft edge of ZJdecelerator has type,hole edge and close edge. The rotating direction are double direction(L)," S”clockwise direction,”N”--anticlockwise and single direction. the shaft installing form are left and right installation.there are totally 12 installing form below.